Constrictor Knot – Step by Step How to Tie It

To know the knot is to constantly find uses for it…

Brion Toss, Master Rigger

This is one of the most effective binding knots. It is constructed as a ‘half knot’ underneath a turn (called a ‘riding’ turn, because it ‘rides’ over the rest of the knot). As a friction binding knot it can be tied with only end of the line, and will hold very tight (sometimes too tight – it can be difficult to untie).

It can be used to quickly bind pretty much anything, at least temporarily, and excels when tied in small line around a larger object, because the thin line ‘bites’ into the object.

animated constrictor knot

The caveat to the knot’s strength is that one must be cautious when using it on softer materials like fabric bags as the line can damage them, especially if very thin. Keeping the different turns of the knot snug up to each other can alleviate this problem slightly by spreading the load a little.

You probably find this knot useful for tying up bundles of firewood or fabric (like tents or sleeping bags), but it can also be good for lashing together similarly-shaped equipment, like pens or pencils or knives in a pack.

End Tying Method

This is the ‘standard’ way to tie a constrictor, and you could get by with just this if you always have the end of the line to hand.

However, it is best used around the middle of a bundle, where it is inconvenient to get to the ends (of the bundle) and so difficult to use the twisting method (which is generally faster).

The Steps

Step 1. Lay the line over the pole working end away from you:

constrictor knot step 1

Step 2. Pass the working end back under the pole, coming out on one side (in this case the right) of the standing part:

constrictor knot step 2

Step 3. Cross the working end back up over the standing part and over the pole. Its should now be on the other side of the standing part (here the left side):

constrictor knot step 3

Step 4. Bring the working end under the pole without crossing anything:

constrictor knot step 4

Step 5. Cross the working end over the standing part:

constrictor knot step 5

Step 6. Thread the standing part under both parts of the turn on the side it is pointing towards (in this case the right side):

constrictor knot step 6

The end result:

standard constrictor knot

Constrictor knot used to bundle some kindling.

The end tying method tends to be especially suited to bundles of many separate items, where it would be impractical to hold the whole bundle and slip a ‘twisted’ method tied constrictor over the end. Instead, it is much easier to lay the items one by one onto a line laid on a surface, then bring the line up and around and tie the knot.

The same principle means that for very thick bundles ‘knotted end’ binding knots tend to be easier to use.

animated constrictor knot Pinterest image

Leave a Reply

Your email address will not be published. Required fields are marked *

Next Post

DIY Off-Road Vehicle Recovery with Rope & Pulleys

Mon Jun 15 , 2020